| |
 |
 |
 |
|
Trigger Housing doesn’t allow full cycle |
February 24, 2024 |
| :
Chris Johnson from Watauga, TX United States
|
|
The trigger housing doesn’t fit into the back of the slide correctly. Making it impossible to break the firearm down or cycle through a round. Its locks back before a complete cycle is complete. Compared to other Glock 19 trigger housing, it is visibly different and non compatible without modification.
-----------------------------------------------------------------------------------------------------------------------------------
MAS Defense Reply: Chris, I apologize for the issue. The trigger housing may look different but dimensionally it should be the same size. There are a few troubleshooting questions we will contact you to go over. 1st, do you have the right generation frame? 2nd is the trigger bar, spring, connector all assembled correctly? 3. You may have to push in on the connector when dropping the housing in the frame to get it to seat correct. We will go more in depth if needed when customer service contacts you.
Thank you for your business and your feedback!
Was this review helpful to you? 
|
|
 |
|
 |
|
